Archive | How To’s RSS feed for this section

Bedding in Your Brake Pads

We recently wrote an article in our Tech Papers section describing the braking procedure and bedding process.  The article is still a little rough, so feel free to give us your comments.    Article Title:  How to Correctly Bed-in Your New Brake rotors and Brake Pads.   Synopsis: At any time you install a new brake pads […]

Read full story Comments { 0 }

Are your brakes vibrating, pulsating, or warped?

The 411 on Brake Judders Many of the people I talk to on a daily basis complained that their brakes are vibrating, pulsating, and that their rotors are warped. This little guide will help you somewhat understand why you are getting that annoying shaking every time you step on the brakes and what you can […]

Read full story Comments { 1 }

How to install Honda Accord brake pads.

Over the weekend, I was searching on Youtube and found a pretty good video install on Honda Accord brake pads. So, I’ve embedded the video below, hoping that it’ll help you install brake pads for your Honda Accord. The presenter in this video installed 2003-2004 Honda Accord Coupe brake pads. NOTE: On the Accord you […]

Read full story Comments { 2 }

How to bleed your brakes and increase performance.

Does your brake pedal feel spongy? Even with new rotors and pads, you just don’t feel the max performance? Many times, this is caused from air being trapped in you brake lines. This is usually do to high heat flex in the brake hoses. Brakes get hot, and when they are hot, your fluids are […]

Read full story Comments { 0 }

Civic/Integra Big Brake Caliper & Rotor Upgrades for LESS?

The content below was provided by BrakeExpert and is posted with his expressed permission.   Did you always wanted a Big Brake Kit for your Honda Civic or Acura Integra, but couldn’t afford it? Now we got some information on how you can save yourself some extra change by upgrading your 10 inch brake rotors […]

Read full story Comments { 0 }

Brake Rotors Conversion Patterns: 4 or 5 Lugs

If you’re doing a custom brake system on your vehicle, we can drill a custom bolt / lug pattern on the brake rotors to make it fit. We’ve done many lug patterns for classic cars, classic trucks, & hot rods. These Riders are usually trying to convert the rear drums to rear brake discs. They […]

Read full story Comments { 2 }